Symmantec doesnt do support for stuff like this, as GHOST is a dead product, but they are willing to sell you a maintenance kit if you want to upgrade your WINPE 2.5 to 3.0 but that should be free.
Intel Ethernet Connection I218 Lm Download Center IFrom the Download Center I found what I thought were the correct drivers.
Intel Ethernet Connection I218 Lm Upgrade Your WINPEIn the EXE, I found some WinPE drivers, but apparently these arent it as Im not able to connect to my network when I boot up using WinPE. Can anyone point me in the right direction to get the correct drivers please Thanks. The Driver package from Dell has actually a Problem (in Version A01). So Ive downloaded the Network Driver directly from here ( Intel Download Center). I tried to add the Drivers to an offline WinPE Image but it seems, sometimes not all files were copied to the Destination. I removed the faulty Driver and readded it, then all files were copied and the NIC was recognized by WinPE. As soon as the machine boots into WinPE, it loses its IP address. Sadly, none of the drivers included seem to be working when I load them with drvload while in WinPE. Have tried adding all drivers from PRO1000Winx64NDIS62 but none work. Checked driver on the computer Im trying to take the image from and it is using e1d62x64.inf. Any other suggestions would be appreciated. This computer have a Intel Ethernet Connection I217-LM controler. When boot on my USB SCCM 2012 media to install Windows 7 x64, I havent IP address. So has said Runner1979, I try to load this driver Pro1000Winx64NDIS63 e1d63x64.inf, and now i have an IP address Now I can add this driver in my SCCM boot image. The driver was from release 18.6 and it was: CatalogFile e1d6332.cat DriverVer 08292013,12.10.30.0. It might be just that since its tagged with sccm2012 that a certain version of WinPE is implied so I apologise if Im incorrect For an observer with other products that use WinPE and this network chipset though it would be useful to specify the exact setup for them to assist. I have a Dell E6540 with the I27-LM and I am using Ghost Console. I have loaded the driver (version 19) from PROWin32PRO1000Win32NDIS62 into my WinPE folder, but upon pulling the original stock image from the Dell I am getting a 127.0.0.1 IP address. I have seen this before with Ghost due to a driver that is not working. ![]() Any Ideas I am trying other versions of this Intel driver (18.7 and 18.6) but it seriously takes 10 minutes to load each driver into Ghost, so I will be around. I got some new computers with intel I217-LM ethernet controller. And I had to make it work with a Windows vista (6.1) 32bit WinPE. Intel Ethernet Connection I218 Lm Exe Using WinrarSo I downloaded the vista driver for I210 ethernet controller, extracted all files from the exe using winrar, then I edited the e1r6032.inf file from folder PRO1000Win32NDIS61. So if you plan to use this method, check the device id of your network card first. We just recently got some dell 7020 and 9020 units and that is why i started to look.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |